Page 1 of 1

Can't edit Harvester owner

Posted: Wed Apr 06, 2016 12:29 pm
by DarioZ
When I try to modify it simply shows the owner name (greyed) and OK, and I can't change the maintenace bonuses.

Am I doing something wrong?

Re: Can't edit Harvester owner

Posted: Thu Apr 07, 2016 4:46 pm
by Sobuno
The Edit dialog was used to set the expertise bonuses only, you were never able to edit the name of the owner. I ripped out a lot of the expertise-related code when I converted it to pre-CU, but have apparently missed the table. The Edit dialog makes no sense now, so I will remove it.

Re: Can't edit Harvester owner

Posted: Fri Apr 08, 2016 8:35 am
by DarioZ
But I have a bonus in maintenance for merchant! Can't we set that bonus there? Otherwise I have every time to hand compute (or set same maintenance as power) to have the value of maintenace necessary.

Can't we set the 20% reduction there?

Re: Can't edit Harvester owner

Posted: Fri Apr 08, 2016 4:46 pm
by Sobuno
Oh, I wasn't aware there were bonuses in pre-CU.

Are there any other bonuses?

Re: Can't edit Harvester owner

Posted: Fri Apr 08, 2016 7:34 pm
by Savacc
No, that is the only bonus in vanilla Pre-CU. Other servers could have anything their little hearts imagine.

I hope we are keeping an NGE version of SWGAide?

Re: Can't edit Harvester owner

Posted: Tue Apr 12, 2016 5:06 pm
by Sobuno
The NGE features can all be found in the Github changelog, but I have not necessarily kept them intact lately.

Re: Can't edit Harvester owner

Posted: Tue Apr 12, 2016 5:18 pm
by Sobuno
Is the bonus a one-off toggle or does it have different levels just like NGE had (Expertise points 1-4)?

Re: Can't edit Harvester owner

Posted: Wed Apr 13, 2016 2:52 am
by Savacc
It is a skill gained in Efficiency IV of Merchant - Reduced Maintenance Fees: 20%
There is only the one level of it available.

Re: Can't edit Harvester owner

Posted: Wed Apr 13, 2016 7:30 pm
by Sobuno
A new release is up now that adds the possibility of adding this buff.

Re: Can't edit Harvester owner

Posted: Fri Apr 15, 2016 7:51 am
by DarioZ
Thank you!!!